Page 1 of 1

Dented Exhaust

Posted: 29 Sep 2005, 19:53
by Celt
I have a few dents in my DEP Sport exhaust pipe.

Is there some kind of exhaust guard that i can put on it to hide the dents?

Or is there a better way round the problem other than buying a new pipe? :?:

Posted: 29 Sep 2005, 20:07
by lee_p
Have a look here viewtopic.php?t=1597&highlight= CRM`ER did his own and looks well. :)

Lee

Posted: 30 Sep 2005, 13:42
by shannonmurray
There are repair shops in the US that take dents out of 2-stroke pipes. They seal off both ends of the pipe, then fill it with compressed air. Next they take a blow torch and heat the area where the dent is. The compressed air in the pipe pops the dent right out.

Posted: 30 Sep 2005, 19:01
by CRMR
I would like to try this , But how would you seal the ends airtight??any ideas

Posted: 01 Oct 2005, 02:52
by shannonmurray
I've never seen it done, just read about it. Maybe they use some kind of high temp rubber cork in each end with a clamp as well. Of course one of the corks would need a tube in it to provide the compressed air.

Here's a link that says, \"Don't try this your self,\" but there are some other good tips on aligning your pipe and taking the carbon out of the inlet.

http://www.piperepair.com/dent.htm

Shannon

Posted: 13 Oct 2005, 14:07
by daven
You can get exhaust 'blow out kits' for this (try racespec, offroad only and the like) - or you may find your local MX shop will do it for a few quid. I'm not sure you can do the standard pipes as they have all the crud in as above, but DEPs and the like should be OK.
I have done mine with a home-made kit (the part of an inner tube with the valve on, clamped over the engine end with a piece of plywood bolted through the mounting holes. Other end plugged with a rubber cork, with a bolt through it so that it expands when the bolt is tightened). The dent has not gone completely.
Any such procedure is potenially risky - if the whole pipe blew/split then who know what would happen to you....
Cheers
Dave

Exhaust repair

Posted: 24 Oct 2005, 22:01
by baldkirky
You can drill tiny holes and grip a screw with the moles ,heat and pull the dent out. Then mig the holes up. then tidy welds with ginder. well it sounds like it should work,thats what welder at work told me. :o

Posted: 27 Oct 2005, 01:19
by shemston_crm
yeah does work kirky all u need is someone who can weld stainless and do a tidy job, blowtorch definately i good idea when pulling the dint get as hot as possible will make life easier.