Got a new set of decals for my CRM which now want fitting. What's the best way of fitting them without making a ballsup of it? Been told to Tcut the panel(s), spray a mist of water on the panel (to help slide the decal into position) then force the water out with a rubber edged spatular.
Anyone tried this or is there a better way?

Ugly

wo,wo,wo m8 ,, You need a little washing upliquid (1 drop) with the water to help it slip m8ty ,, then you can squeegy it out ,, dont touch it for 24 hours till its dry and your done ,,,,,ok

yes soapy water but only use the bubbles,not the water lets you position it properly by sliding it around,until you are happy with the position then squeedjey out any bubbles

Once you have em in position and stuck use a hair dryer to warm both them and the plastics up, use a soft cloth to press them into position working from the centre out (small circular motion works best) DONT let em get too hot !, once you have done this they will stay attached even if you jet wash.