Hi all ,i had my rear wheel oof my mk2 as i was changing the c & s , the wheel bearings seem to have a tad of play when the bike is raised etc ,are the bearing covers a flat disc with four holes in ( similar looking to something thats on an angle grinder) that unscrew ,or should there be bolts/screws holding this down ? and mine are all snapped !!!! or can i view a manual somewhere ? Many thx Rob

Sounds like punch and hammer time, [ oh oh oh hammer time ], unscrew the cover plate to reveal the bearing therein.
I don't think there's any clip as well, but check to make sure, or others with greater knowledge might comment.
Mike

Cheers for the reply ,manged to find a wheel picture showing that they screw in ,,,,ie hammer n punch lol Thx again,Just posted a pic on members bikes ,if u wanna see my bike

http://www.ebay.co.uk/itm/Honda-XR-Bear ... Fi8oqfDRHQ

I bought this tool when I did my Mk2 rear wheel bearings a couple of weeks ago, fits perfectly.

griff76 wrote:http://www.ebay.co.uk/itm/Honda-XR-Bear ... Fi8oqfDRHQ

I bought this tool when I did my Mk2 rear wheel bearings a couple of weeks ago, fits perfectly.

That'll do the job, sometimes one of the angle grinder tools will fit, but not always well.
Seals will probably be fuburded as well.

Mike

Perfect thread, exactly what I am looking for. Get one of them ordered now. Cheers guys


Sent from my iPhone using Tapatalk