Hi Bargos,

Just a thought - maybe you should replace the bearing race's as the heat from the coating process may have taken the temper out of the steel and will leave them softer than before.

As I said, just a thought.

Robb

Hi

Had the same with my Mk2. Just pulled the whole sender unit to pieces and rebuilt the whole top end of it with silicone sealant and it don't leek no more.
Be careful if thats what u r going to do because it can break real easey and dont get any on the float switch thingy.

hope this helps

Robb

Hi Cat,

Gotta agree with Russell about the running-on. Lean mixture and carbon build up don't mix and could cause the problem you have described.
This may also cause poor idle.
Lean mixture could also cause the bogging down as you lift the carb slide quickly and weaken the mixture to the point ...

Well thanx for the response guys :D

It seems as though its just one o them things and there are enough of you with the same noise for me not to worry about it. :wink:

Its just got me puzzled a bit. Ive worked on 2strokes for many years and have extracted damn good horsepower out of Yam LC & YPVS ...

Hi Guys,

Got a bit of a strange noise going on with my MK2.
Its a kind of vibrating metalic rattle that you only hear at low RPM if you give the bike some throttle in too high a gear. If your gentle with the throttle the bike pulls through it cleanly, If your harsh with the throttle thats when it ...

Hi James,

Just a bit of general advice - Ive had some probs with my electrics!!!

Make sure that you have got a good earth to the frame and not isolated by paint and muck etc.

Check your connector blocks and terminals for fusty blue corrosion that builds up and breaks the connection.

Check your ...