It had a top end rebild after piston siezure,oil pump stopped working.
so it had rebore, new piston rings, and gasket set.

Sorry if i am being unclear, my question is is there anything else i could check or perhaps some one has another experience that could be a possible solution.

Hi all after not being able to start my mark 2.2 i tried to start the engine with some extra gas.
see my last post re should i set fire to it.
It worked. I used easy start sprayed into the throat of the carb with the air filter off and the engine ran. It really ran. fast. The engine started and ran ...

had a look at it last night, it had loads of play in crank...
i needed one too.

In red or blue please contact me for details

hi ed,
just had my crank bearings go, started to make a wining nosie and just as the previous post said about give the rotor a shake i did and found movment, you should also feel it vibrating though your seat.
as to the cost iv spent £200 so far with LT. however around £90 of this was on the water ...

my advice is to rev it out-remember its a 2 stroke and it is designed to be revved HARD. If you were to ride it like a 4 srtoke then you will be more likely to run into all sorts of trouble. These bikes dont have bags of low end tourque to pull you out of trouble, get the engine singing.

I'd gladly put the mk2 ones on my bike all white bike to provide everyone with a review , of course i would be willing to make a contribution toward development costs!

i wish i spoke Japanese

Hi admin whats the cost going to be?
red attacker for me for the mk2

what about the 'glay' set????? phonetic spelling at its best!

Hi all, i have finished putting my mk2.2 back together and now i need some decals.
does anyone.........
know if any other models fit?
has anyone got a cheap set from somewhere other than Lei$ure Trail? if do lemme know please!
have you got a set for sale?

Cheers,
Nick.

ill start looking in the shed tommorow or order one from leisuretrail in the morning.

Hi all i have a small problem,
can you tell me if the mk2.2 has a front wheel spacer?

I have reassembled the caliper and front wheel and now the disc rubs against the brake caliper, it didn't before.
which leads me to deduce i have lost a spacer, except i cannot remember if there was one before ...

I replaced mine after various attempts to bodge it over 25 notes from David Silver spares. If i remember rightly it was a tight fit!!!

hi all whats the settings for the front and rear axles on a mk2.2?